The P1 Unit was designed and built with PFAS treatment in mind, however the technology within it evolved from
broader hydrocarbon treatment applications. With a varied catalogue of specialist MyCelx filter cartridges
available, the system is flexible enough to face a variety of hydrocarbon challenges. The twelve filter housings within P1 contain twenty 40” cartridge filters each, and can be run in a single series of twelve vessels, or as two
parallel trains of six filters each.

Housings can be set up with simple sediment filters in a variety of micron ratings, through to cartridges infused with materials that target specific organic compounds
and bind them to the cartridge, removing them
permanently from the effluent stream. Combinations can be tailored to suit the specific effluent matrix.

• Simple to use
• Remote monitoring of system pressures to observe filter condition
• Easy to customize however, thorough water analysis is necessary prior to specification
• Low power requirement
• Potentially high consumables cost so correct cartridge set up is essential.

Max Flow l/sec20 L /s (parallel operation)
Size6000L x 2400W x 2900H

While this pump / equipment matches your duty criteria, other factors may determine the suitability and therefore NPE advise that you contact us to discuss your requirement.

Get in touch to discuss your requirements...

Call Us

NPE has not only one of the largest ranges of specialised equipment, but also the most qualified professionals in pumping and power generation in Australia.

Visit A Location

The NPE branch network is strategically positioned to service all parts of Australia. These hire branches are supported by a team of NPE representatives and field service crews.

© National Pump & Energy 2024

Website created by RJ New Designs